Forum: Gargoyle v1.3.7 i brak obsługi HDD

Kod Pobierz kod źródłowy
root@Wl500Gp:~# dmesg

CPU revision is: 00029006

Primary instruction cache 16kB, physically tagged, 2-way, linesize 16 bytes.

Primary data cache 16kB, 2-way, linesize 16 bytes.

Linux version 2.4.37.9 (eric@Osiris) (gcc version 3.4.6 (OpenWrt-2.0)) #3 Wed Nov 3 20:45:21 EDT 2010

Setting the PFC to its default value

Determined physical RAM map:

 memory: 02000000 @ 00000000 (usable)

On node 0 totalpages: 8192

zone(0): 8192 pages.

zone(1): 0 pages.

zone(2): 0 pages.

Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200

CPU: BCM4704 rev 9 at 264 MHz

Using 132.000 MHz high precision timer.

Calibrating delay loop... 262.96 BogoMIPS

Memory: 30460k/32768k available (1440k kernel code, 2308k reserved, 96k data, 84k init, 0k highmem)

Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)

Inode cache hash table entries: 2048 (order: 2, 16384 bytes)

Mount cache hash table entries: 512 (order: 0, 4096 bytes)

Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)

Page-cache hash table entries: 8192 (order: 3, 32768 bytes)

Checking for 'wait' instruction...  unavailable.

POSIX conformance testing by UNIFIX

PCI: Initializing host

PCI: Fixing up bus 0

PCI: Fixing up bridge

PCI: Setting latency timer of device 01:00.0 to 64

PCI: Fixing up bus 1

Linux NET4.0 for Linux 2.4

Based upon Swansea University Computer Society NET3.039

Initializing RT netlink socket

Starting kswapd

Registering mini_fo version $Id$

devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)

devfs: boot_options: 0x1

JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB.

squashfs: version 3.0 (2006/03/15) Phillip Lougher

pty: 256 Unix98 ptys configured

Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled

ttyS00 at 0xb8000300 (irq = 3) is a 16550A

ttyS01 at 0xb8000400 (irq = 3) is a 16550A

b44.c:v0.93 (Mar, 2004)

PCI: Setting latency timer of device 00:01.0 to 64

eth0: Broadcom 47xx 10/100BaseT Ethernet 00:1f:c6:36:ea:25

PCI: Setting latency timer of device 00:02.0 to 64

eth1: Broadcom 47xx 10/100BaseT Ethernet 40:10:18:00:00:2d

Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0

Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0

Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0

 Amd/Fujitsu Extended Query Table v1.3 at 0x0040

number of CFI chips: 1

cfi_cmdset_0002: Disabling fast programming due to code brokenness.

Flash device: 0x800000 at 0x1c000000

bootloader size: 262144

Physically mapped flash: Filesystem type: squashfs, size=0x2403cf

Creating 5 MTD partitions on "Physically mapped flash":

0x00000000-0x00040000 : "cfe"

0x00040000-0x007f0000 : "linux"

0x000bb400-0x00300000 : "rootfs"

mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only

0x007f0000-0x00800000 : "nvram"

0x00300000-0x007f0000 : "rootfs_data"

sflash: found no supported devices

Initializing Cryptographic API

NET4: Linux TCP/IP 1.0 for NET4.0

IP Protocols: ICMP, UDP, TCP, IGMP

IP: routing cache hash table of 512 buckets, 4Kbytes

TCP: Hash tables configured (established 2048 bind 4096)

Linux IP multicast router 0.06 plus PIM-SM

NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.

NET4: Ethernet Bridge 008 for NET4.0

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly.

Mounted devfs on /dev

Freeing unused kernel memory: 84k freed

diag: Detected 'ASUS WL-500g Premium'

b44: eth0: Link is up at 100 Mbps, full duplex.

b44: eth0: Flow control is off for TX and off for RX.

roboswitch: Probing device eth0: found a 5325! It's a 5350.

mini_fo: using base directory: /

mini_fo: using storage directory: /overlay

jffs2.bbc: SIZE compression mode activated.

b44: eth0: Link is up at 100 Mbps, full duplex.

b44: eth0: Flow control is off for TX and off for RX.

SCSI subsystem driver Revision: 1.00

eth0.1: add 01:00:5e:00:00:01 mcast address to master interface

eth0.0: add 01:00:5e:00:00:01 mcast address to master interface

eth0.0: dev_set_promiscuity(master, 1)

device eth0 entered promiscuous mode

device eth0.0 entered promiscuous mode

br-lan: port 1(eth0.0) entering learning state

br-lan: port 1(eth0.0) entering forwarding state

br-lan: topology change detected, propagating

usb.c: registered new driver usbdevfs

usb.c: registered new driver hub

PCI: Setting latency timer of device 01:02.0 to 64

PCI: Enabling device 01:02.0 (0004 -> 0006)

PCI/DMA

wl0: wlc_attach: chiprev 2 coreunit 0 corerev 9 cccap 0x640009 maccap 0x0 band 2.4G, phy_type 2 phy_rev 7 ana_rev 3

wl0: Broadcom BCM4318 802.11 Wireless Controller 4.150.10.5

CSLIP: code copyright 1989 Regents of the University of California

PPP generic driver version 2.4.2

Journalled Block Device driver loaded

ip_tables: (C) 2000-2002 Netfilter core team

PCI: Enabling device 01:03.2 (0000 -> 0002)

ehci_hcd 01:03.2: PCI device 1106:3104

ehci_hcd 01:03.2: irq 2, pci mem c01e6000

usb.c: new USB bus registered, assigned bus number 1

EHCI: Enabling VIA 6212 workarounds

ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4

hub.c: USB hub found

hub.c: 4 ports detected

ip_conntrack version 2.1 (5953 buckets, 5953 max) - 352 bytes per conntrack

ipt_recent v0.3.1: Stephen Frost .  http://snowman.net/projects/ipt_recent/

hub.c: new USB device 01:03.2-2, assigned address 2

usb.c: USB device 2 (vend/prod 0x152d/0x2338) is not claimed by any active driver.

        Hooked IMQ after mangle on PREROUTING

        Hooked IMQ after nat on POSTROUTING

imq driver loaded.

SB USB 1.1 init

PCI: Setting latency timer of device 00:03.0 to 64

usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6

usb-ohci.c: usb-00:03.0, PCI device 14e4:4715

usb.c: new USB bus registered, assigned bus number 2

hub.c: USB hub found

hub.c: 2 ports detected

uhci.c: USB Universal Host Controller Interface driver v1.1

PCI: Enabling device 01:03.0 (0000 -> 0001)

uhci.c: USB UHCI at I/O 0x100, IRQ 2

usb.c: new USB bus registered, assigned bus number 3

hub.c: USB hub found

hub.c: 2 ports detected

PCI: Enabling device 01:03.1 (0000 -> 0001)

uhci.c: USB UHCI at I/O 0x120, IRQ 2

usb.c: new USB bus registered, assigned bus number 4

hub.c: USB hub found

hub.c: 2 ports detected

usb-uhci.c: $Revision: 1.275 $ time 09:17:22 Apr  1 2010

usb-uhci.c: High bandwidth mode enabled

usb-uhci.c: v1.275:USB Universal Host Controller Interface driver

Initializing USB Mass Storage driver...

usb.c: registered new driver usb-storage

scsi0 : SCSI emulation for USB Mass Storage devices

  Vendor: FUJITSU   Model: MHV2080AH PL      Rev: 00A0

  Type:   Direct-Access                      ANSI SCSI revision: 02

Attached scsi disk sda at scsi0, channel 0, id 0, lun 0

SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)

Partition check:

 /dev/scsi/host0/bus0/target0/lun0: p1 p2

WARNING: USB Mass Storage data integrity not assured

USB Mass Storage device found at 2

USB Mass Storage support registered.

Adding Swap: 546200k swap-space (priority -1)

device wl0 entered promiscuous mode

wl0: attempt to add interface with same source address.

br-lan: port 2(wl0) entering learning state

br-lan: port 2(wl0) entering forwarding state

br-lan: topology change detected, propagating