_______                     ________        __

 |       |.-----.-----.-----.|  |  |  |.----.|  |_

 |   -   ||  _  |  -__|     ||  |  |  ||   _||   _|

 |_______||   __|_____|__|__||________||__|  |____|

          |__| W I R E L E S S   F R E E D O M

 Backfire (10.03.x, latest version. Always.) -------

  * 1/3 shot Kahlua    In a shot glass, layer Kahlua

  * 1/3 shot Bailey's  on the bottom, then Bailey's,

  * 1/3 shot Vodka     then Vodka.

 ----------( by obsy, http://eko.one.pl/ )----------

root@Gargoyle:~# dmesg

Linux version 2.6.32.16 (cezary@eko.one.pl) (gcc version 4.3.3 (GCC) ) #19 Sat Nov 6 23:34:04 CET 2010

prom: fw_arg0=00000007, fw_arg1=a1f77fb0, fw_arg2=a1f78440, fw_arg3=00000008

MyLoader: sysp=00000000, boardp=00000000, parts=00000000

bootconsole [early0] enabled

CPU revision is: 00019374 (MIPS 24Kc)

Atheros AR9132 rev 2, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz

Determined physical RAM map:

 memory: 02000000 @ 00000000 (usable)

Initrd not found or empty - disabling initrd

Zone PFN ranges:

  Normal   0x00000000 -> 0x00002000

Movable zone start PFN for each node

early_node_map[1] active PFN ranges

    0: 0x00000000 -> 0x00002000

On node 0 totalpages: 8192

free_area_init_node: node 0, pgdat 802c7fd0, node_mem_map 81000000

  Normal zone: 64 pages used for memmap

  Normal zone: 0 pages reserved

  Normal zone: 8128 pages, LIFO batch:0

Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128

Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=TL-WR1043ND

PID hash table entries: 128 (order: -3, 512 bytes)

Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)

Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)

Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.

Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes

Writing ErrCtl register=00000000

Readback ErrCtl register=00000000

Memory: 29348k/32768k available (2074k kernel code, 3420k reserved, 392k data, 152k init, 0k highmem)

SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1

Hierarchical RCU implementation.

NR_IRQS:56

Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)

Mount-cache hash table entries: 512

NET: Registered protocol family 16

MIPS: machine is TP-LINK TL-WR1043ND

bio: create slab  at 0

Switching to clocksource MIPS

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 1024 (order: 1, 8192 bytes)

TCP bind hash table entries: 1024 (order: 0, 4096 bytes)

TCP: Hash tables configured (established 1024 bind 1024)

TCP reno registered

NET: Registered protocol family 1

squashfs: version 4.0 (2009/01/31) Phillip Lougher

Registering mini_fo version $Id$

JFFS2 version 2.2. (NAND) (SUMMARY)  Š 2001-2006 Red Hat, Inc.

yaffs Nov  2 2010 18:35:03 Installing.

msgmni has been set to 57

io scheduler noop registered

io scheduler deadline registered (default)

Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled

serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A

console [ttyS0] enabled, bootconsole disabled

Atheros AR71xx SPI Controller driver version 0.2.4

m25p80 spi0.0: m25p64 (8192 Kbytes)

spi0.0: searching for MyLoader partition table at offset 0x10000

spi0.0: searching for MyLoader partition table at offset 0x20000

spi0.0: searching for MyLoader partition table at offset 0x30000

spi0.0: searching for MyLoader partition table at offset 0x40000

spi0.0: no MyLoader partition table found

Searching for RedBoot partition table in spi0.0 at offset 0x7e0000

Searching for RedBoot partition table in spi0.0 at offset 0x7f0000

No RedBoot partition table detected in spi0.0

spi0.0: no WRT160NL signature found

Creating 5 MTD partitions on "spi0.0":

0x000000000000-0x000000020000 : "u-boot"

0x000000020000-0x000000160000 : "kernel"

0x000000160000-0x0000007f0000 : "rootfs"

mtd: partition "rootfs" set to be root filesystem

mtd: partition "rootfs_data" created automatically, ofs=4E0000, len=310000

0x0000004e0000-0x0000007f0000 : "rootfs_data"

0x0000007f0000-0x000000800000 : "art"

0x000000020000-0x0000007f0000 : "firmware"

Realtek RTL8366RB ethernet switch driver version 0.2.2

rtl8366rb rtl8366rb: using GPIO pins 18 (SDA) and 19 (SCK)

rtl8366rb rtl8366rb: RTL5937 ver. 3 chip found

rtl8366rb: probed

eth0: Atheros AG71xx at 0xb9000000, irq 4

eth0: using fixed link parameters

Atheros AR71xx hardware watchdog driver version 0.1.0

ar71xx-wdt: timeout=15 secs (max=21)

TCP westwood registered

NET: Registered protocol family 17

Bridge firewalling registered

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly on device 31:2.

Freeing unused kernel memory: 152k freed

Please be patient, while OpenWrt loads ...

gpio-buttons driver version 0.1.2

input: gpio-buttons as /devices/platform/gpio-buttons/input/input0

Button Hotplug driver version 0.3.1

ar71xx: pll_reg 0xb8050014: 0x1a000000

eth0: link up (1000Mbps/Full duplex)

Registered led device: tl-wr1043nd:green:usb

Registered led device: tl-wr1043nd:green:system

Registered led device: tl-wr1043nd:green:qss

Registered led device: tl-wr1043nd:green:wlan

mini_fo: using base directory: /

mini_fo: using storage directory: /overlay

eth0: link down

ar71xx: pll_reg 0xb8050014: 0x1a000000

eth0: link up (1000Mbps/Full duplex)

device eth0.1 entered promiscuous mode

device eth0 entered promiscuous mode

br-lan: port 1(eth0.1) entering forwarding state

Compat-wireless backport release: compat-wireless-2010-10-14-7-gab01eca

Backport based on wireless-testing.git master-2010-10-19

cfg80211: Calling CRDA to update world regulatory domain

SCSI subsystem initialized

cfg80211: World regulatory domain updated:

    (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)

    (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)

    (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)

    (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

usbcore: registered new interface driver usbfs

usbcore: registered new interface driver hub

usbcore: registered new device driver usb

ath: EEPROM regdomain: 0x0

ath: EEPROM indicates default country code should be used

ath: doing EEPROM country->regdmn map search

ath: country maps to regdmn code: 0x3a

ath: Country alpha2 being used: US

ath: Regpair used: 0x3a

ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'

ieee80211 phy0: Atheros AR9100 MAC/BB Rev:0 AR2133 RF Rev:a2 mem=0xb80c0000, irq=2

cfg80211: Calling CRDA for country: US

NET: Registered protocol family 8

NET: Registered protocol family 20

PPP generic driver version 2.4.2

cfg80211: Regulatory domain changed to country: US

    (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)

    (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)

    (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)

    (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)

ip_tables: (C) 2000-2006 Netfilter Core Team

NET: Registered protocol family 24

ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver

ar71xx-ehci ar71xx-ehci: Atheros AR91xx built-in EHCI controller

ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1

ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000

ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00

usb usb1: configuration #1 chosen from 1 choice

hub 1-0:1.0: USB hub found

hub 1-0:1.0: 1 port detected

nf_conntrack version 0.5.0 (460 buckets, 1840 max)

CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use

nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or

sysctl net.netfilter.nf_conntrack_acct=1 to enable it.

usb 1-1: new full speed USB device using ar71xx-ehci and address 2

usb 1-1: configuration #1 chosen from 1 choice

xt_time: kernel timezone is -0000

        Hooked IMQ after mangle on PREROUTING

        Hooked IMQ after nat on POSTROUTING

IMQ driver loaded successfully.

Ebtables v2.0 registered

uhci_hcd: USB Universal Host Controller Interface driver

usbcore: registered new interface driver usbserial

USB Serial support registered for generic

usbcore: registered new interface driver usbserial_generic

usbserial: USB Serial Driver core

Initializing USB Mass Storage driver...

usbcore: registered new interface driver usb-storage

USB Mass Storage support registered.

usbcore: registered new interface driver ums-alauda

usbcore: registered new interface driver ums-cypress

usbcore: registered new interface driver ums-datafab

usbcore: registered new interface driver ums-freecom

usbcore: registered new interface driver ums-isd200

usbcore: registered new interface driver ums-jumpshot

usbcore: registered new interface driver ums-karma

usbcore: registered new interface driver ums-sddr09

usbcore: registered new interface driver ums-sddr55

usbcore: registered new interface driver ums-usbat

USB Serial support registered for GSM modem (1-port)

usbcore: registered new interface driver option

option: v0.7.2:USB Driver for GSM modems

fuse init (API version 7.13)

device wlan0 entered promiscuous mode

br-lan: port 2(wlan0) entering forwarding state

device wlan0 left promiscuous mode

br-lan: port 2(wlan0) entering disabled state

device wlan0 entered promiscuous mode

br-lan: port 2(wlan0) entering forwarding state

ar71xx-wdt: enabling watchdog timer

usb 1-1: USB disconnect, address 2

usb 1-1: new full speed USB device using ar71xx-ehci and address 3

usb 1-1: configuration #1 chosen from 1 choice

usb 1-1: USB disconnect, address 3