lsusb

Bus 001 Device 003: ID 12d1:1506 

Bus 001 Device 001: ID 1d6b:0002 



dmesg:

Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #16 Tue Feb 26 02:03:59 CET 2013 

CPU revision is: 00019740 

Found a 8MB ST compatible serial flash 

Determined physical RAM map: 

 memory: 04000000 @ 00000000 (usable) 

On node 0 totalpages: 16384 

  Normal zone: 128 pages used for memmap 

  Normal zone: 0 pages reserved 

  Normal zone: 16256 pages, LIFO batch:3 

Built 1 zonelists.  Total pages: 16256 

Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200 

Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. 

Primary data cache 32kB, 4-way, linesize 32 bytes. 

Synthesized TLB refill handler (20 instructions). 

Synthesized TLB load handler fastpath (32 instructions). 

Synthesized TLB store handler fastpath (32 instructions). 

Synthesized TLB modify handler fastpath (31 instructions). 

PID hash table entries: 256 (order: 8, 1024 bytes) 

CPU: BCM4716 rev 1 pkg 10 at 453 MHz 

Using 226.500 MHz high precision timer. 

console [ttyS0] enabled 

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) 

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) 

Memory: 61860k/65536k available (33k kernel code, 3612k reserved, 2726k data, 116k init, 0k highmem) 

Calibrating delay loop... 226.09 BogoMIPS (lpj=1130496) 

Mount-cache hash table entries: 512 

NET: Registered protocol family 16 

PCI: Using membase 8000000 

PCI: Disabled 

PCI: Fixing up bus 0 

PCI: Fixing up bus 1 

NET: Registered protocol family 2 

Time: MIPS clocksource has been installed. 

IP route cache hash table entries: 1024 (order: 0, 4096 bytes) 

TCP established hash table entries: 2048 (order: 2, 16384 bytes) 

TCP bind hash table entries: 2048 (order: 1, 8192 bytes) 

TCP: Hash tables configured (established 2048 bind 2048) 

TCP reno registered 

squashfs: version 3.0 (2006/03/15) Phillip Lougher 

io scheduler noop registered (default) 

HDLC line discipline: version $Revision: 4.8 $, maxframe=4096 

N_HDLC line discipline registered. 

Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled 

serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A 

PPP generic driver version 2.4.2 

MPPE/MPPC encryption/compression module registered 

NET: Registered protocol family 24 

PPPoL2TP kernel driver, V0.18.3 

PPTP driver version 0.8.5 

pflash: found no supported devices 

Creating 6 MTD partitions on "sflash": 

0x00000000-0x00040000 : "pmon" 

0x00040000-0x00790000 : "linux" 

0x00127800-0x00780000 : "rootfs" 

0x00780000-0x00800000 : "jffs2" 

0x007f0000-0x00800000 : "nvram" 

0x007e0000-0x007f0000 : "board_data" 

u32 classifier 

    OLD policer on  

Netfilter messages via NETLINK v0.30. 

nf_conntrack version 0.5.0 (512 buckets, 4096 max) 

ip_tables: (C) 2000-2006 Netfilter Core Team 

ipt_account 0.1.21 : Piotr Gasidlo , http://www.barbara.eu.org/~quaker/ipt_account/ 

net/ipv4/netfilter/tomato_ct.c [Feb 26 2013 01:42:08] 

NET: Registered protocol family 1 

NET: Registered protocol family 10 

ip6_tables: (C) 2000-2006 Netfilter Core Team 

NET: Registered protocol family 17 

802.1Q VLAN Support v1.8 Ben Greear  

All bugs added by David S. Miller  

VFS: Mounted root (squashfs filesystem) readonly. 

Freeing unused kernel memory: 116k freed 

Warning: unable to open an initial console. 

emf: module license 'Proprietary' taints kernel. 

PCI: Setting latency timer of device 0000:00:02.0 to 64 

eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.147.0 

PCI: Setting latency timer of device 0000:00:01.0 to 64 

eth1: Broadcom BCM4329 802.11 Wireless Controller 5.10.147.0 

Algorithmics/MIPS FPU Emulator v1.5 

usbcore: registered new interface driver usbfs 

usbcore: registered new interface driver hub 

usbcore: registered new device driver usb 

ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver 

PCI: Setting latency timer of device 0000:00:04.1 to 64 

ehci_hcd 0000:00:04.1: EHCI Host Controller 

ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1 

ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000 

ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00 

usb usb1: configuration #1 chosen from 1 choice 

hub 1-0:1.0: USB hub found 

hub 1-0:1.0: 2 ports detected 

vlan1: add 33:33:00:00:00:01 mcast address to master interface 

vlan1: add 01:00:5e:00:00:01 mcast address to master interface 

vlan1: dev_set_allmulti(master, 1) 

vlan1: dev_set_promiscuity(master, 1) 

device eth0 entered promiscuous mode 

device vlan1 entered promiscuous mode 

usb 1-1: new high speed USB device using ehci_hcd and address 2 

usb 1-1: configuration #1 chosen from 1 choice 

device eth1 entered promiscuous mode 

br0: port 2(eth1) entering forwarding state 

br0: port 1(vlan1) entering forwarding state 

vlan2: Setting MAC address to  e0 91 f5 6c c2 b1. 

vlan2: add 33:33:00:00:00:01 mcast address to master interface 

vlan2: add 01:00:5e:00:00:01 mcast address to master interface 

IMQ starting with 2 devices... 

IMQ driver loaded successfully. 

   Hooking IMQ after NAT on PREROUTING. 

   Hooking IMQ before NAT on POSTROUTING. 

usb 1-1: USB disconnect, address 2 

usb 1-1: new high speed USB device using ehci_hcd and address 3 

usb 1-1: configuration #1 chosen from 1 choice 

usbcore: registered new interface driver cdc_acm 

drivers/usb/class/cdc-acm.c: v0.26:USB Abstract Control Model driver for USB modems and ISDN adapters 

usbcore: registered new interface driver usbserial 

drivers/usb/serial/usb-serial.c: USB Serial support registered for generic 

usbcore: registered new interface driver usbserial_generic 

drivers/usb/serial/usb-serial.c: USB Serial Driver core 

drivers/usb/serial/usb-serial.c: USB Serial support registered for GSM modem (1-port) 

usbcore: registered new interface driver option 

drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.2 

drivers/usb/serial/usb-serial.c: USB Serial support registered for Sierra USB modem 

usbcore: registered new interface driver sierra 

drivers/usb/serial/sierra.c: USB Driver for Sierra Wireless USB modems: v.1.7.0 

usbcore: deregistering interface driver sierra 

drivers/usb/serial/usb-serial.c: USB Serial deregistering driver Sierra USB modem 

usbcore: deregistering interface driver option 

drivers/usb/serial/usb-serial.c: USB Serial deregistering driver GSM modem (1-port) 

usbcore: deregistering interface driver usbserial_generic 

drivers/usb/serial/usb-serial.c: USB Serial deregistering driver generic 

usbcore: deregistering interface driver usbserial 

usbcore: registered new interface driver usbserial 

drivers/usb/serial/usb-serial.c: USB Serial support registered for generic 

usbserial_generic 1-1:1.0: generic converter detected 

usb 1-1: generic converter now attached to ttyUSB0 

usbserial_generic 1-1:1.1: Generic device with no bulk out, not allowed. 

usbserial_generic: probe of 1-1:1.1 failed with error -5 

usbserial_generic 1-1:1.2: generic converter detected 

usb 1-1: generic converter now attached to ttyUSB1 

usbserial_generic 1-1:1.3: generic converter detected 

usb 1-1: generic converter now attached to ttyUSB2 

usbcore: registered new interface driver usbserial_generic 

drivers/usb/serial/usb-serial.c: USB Serial Driver core 

vlan2: del 01:00:5e:00:00:01 mcast address from vlan interface 

vlan2: del 01:00:5e:00:00:01 mcast address from master interface 

vlan2: del 33:33:00:00:00:01 mcast address from vlan interface 

vlan2: del 33:33:00:00:00:01 mcast address from master interface 

vlan2: Setting MAC address to  e0 91 f5 6c c2 b1. 

vlan2: add 01:00:5e:00:00:01 mcast address to master interface 

vlan2: add 33:33:00:00:00:01 mcast address to master interface 

vlan2: del 33:33:00:00:00:01 mcast address from vlan interface 

vlan2: del 33:33:00:00:00:01 mcast address from master interface 

vlan2: del 01:00:5e:00:00:01 mcast address from vlan interface 

vlan2: del 01:00:5e:00:00:01 mcast address from master interface 

br0: port 2(eth1) entering disabled state 

br0: port 1(vlan1) entering disabled state 

vlan1: del 01:00:5e:00:00:01 mcast address from vlan interface 

vlan1: del 01:00:5e:00:00:01 mcast address from master interface 

vlan1: del 33:33:00:00:00:01 mcast address from vlan interface 

vlan1: del 33:33:00:00:00:01 mcast address from master interface 

device vlan1 left promiscuous mode 

br0: port 1(vlan1) entering disabled state 

device eth1 left promiscuous mode 

br0: port 2(eth1) entering disabled state 

vlan1: add 33:33:00:00:00:01 mcast address to master interface 

vlan1: add 01:00:5e:00:00:01 mcast address to master interface 

device eth1 entered promiscuous mode 

br0: port 2(eth1) entering forwarding state 

br0: port 1(vlan1) entering forwarding state 

vlan2: Setting MAC address to  e0 91 f5 6c c2 b1. 

vlan2: add 33:33:00:00:00:01 mcast address to master interface 

vlan2: add 01:00:5e:00:00:01 mcast address to master interface 

vlan2: del 01:00:5e:00:00:01 mcast address from vlan interface 

vlan2: del 01:00:5e:00:00:01 mcast address from master interface 

vlan2: del 33:33:00:00:00:01 mcast address from vlan interface 

vlan2: del 33:33:00:00:00:01 mcast address from master interface 

vlan2: Setting MAC address to  e0 91 f5 6c c2 b1. 

vlan2: add 01:00:5e:00:00:01 mcast address to master interface 

vlan2: add 33:33:00:00:00:01 mcast address to master interface 

vlan2: del 33:33:00:00:00:01 mcast address from vlan interface 

vlan2: del 33:33:00:00:00:01 mcast address from master interface 

vlan2: del 01:00:5e:00:00:01 mcast address from vlan interface 

vlan2: del 01:00:5e:00:00:01 mcast address from master interface 

vlan2: Setting MAC address to  e0 91 f5 6c c2 b1. 

vlan2: add 01:00:5e:00:00:01 mcast address to master interface 

vlan2: add 33:33:00:00:00:01 mcast address to master interface