Decompressing...........done





CFE version 1.0.37 for BCM947XX (32bit,SP,LE)

Build Date: Thu Jul 19 10:53:24 CST 2007 (root@redhat9)

Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.



Initializing Arena

Initializing Devices.

Boot partition size = 262144(0x40000)

et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 4.150.3.0

CPU type 0x29029: 240MHz

Total memory: 32768 KBytes



Total memory used by CFE:  0x80300000 - 0x803C0720 (788256)

Initialized Data:          0x80337730 - 0x8033AE50 (14112)

BSS Area:                  0x8033AE50 - 0x8033C720 (6352)

Local Heap:                0x8033C720 - 0x803A0720 (409600)

Stack Area:                0x803A0720 - 0x803C0720 (131072)

Text (code) segment:       0x80300000 - 0x80337730 (227120)

Boot area (physical):      0x003C1000 - 0x00401000

Relocation Factor:         I:00000000 - D:00000000



alpha bootcode ver 0.1.2

cmd = ifconfig eth0 -addr=192.168.0.1 -mask=255.255.255.0

We disable the arp for self.

We disable the arp for self.

Device eth0:  hwaddr 00-90-4C-C0-00-01, ipaddr 192.168.0.1, mask 255.255.255.0

        gateway not set, nameserver not set

cmd = go;

cmd = load -raw -addr=0x803c0720 -max=0x3a0000 :

Loader:raw Filesys:tftp Dev:eth0 File:: Options:(null)

Loading: Failed.

Could not load :: Timeout occured

Dest=80001000, source =803c0720, filename=flash1.trx

cmd = boot -raw -z -addr=0x80001000 -max=0x3a0000 flash0.os:

Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)

Loading: entry point=80001000

.. 4092 bytes read

Entry at 0x80001000

Closing network.

Starting program at 0x80001000

Linux version 2.6.34.1 (root@6930) (gcc version 4.3.3 (GCC) ) #1 Tue Jul 27 15:3                                                                                9:25 CEST 2010

CPU revision is: 00029029 (Broadcom BCM3302)

ssb: Sonics Silicon Backplane found at address 0x18000000

Determined physical RAM map:

 memory: 02000000 @ 00000000 (usable)

Initrd not found or empty - disabling initrd

Zone PFN ranges:

  Normal   0x00000000 -> 0x00002000

Movable zone start PFN for each node

early_node_map[1] active PFN ranges

    0: 0x00000000 -> 0x00002000

Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128

Kernel command line:  root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd con                                                                                sole=ttyS0,115200

PID hash table entries: 128 (order: -3, 512 bytes)

Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)

Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)

Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes.

Primary data cache 16kB, 2-way, VIPT, cache aliases, linesize 16 bytes

Memory: 29660k/32768k available (2208k kernel code, 3108k reserved, 326k data, 1                                                                                48k init, 0k highmem)

NR_IRQS:128

console [ttyS0] enabled

Calibrating delay loop... 239.10 BogoMIPS (lpj=478208)

Mount-cache hash table entries: 512

NET: Registered protocol family 16

bio: create slab  at 0

Switching to clocksource MIPS

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 1024 (order: 1, 8192 bytes)

TCP bind hash table entries: 1024 (order: 0, 4096 bytes)

TCP: Hash tables configured (established 1024 bind 1024)

TCP reno registered

UDP hash table entries: 256 (order: 0, 4096 bytes)

UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)

NET: Registered protocol family 1

init_vdso successfull

squashfs: version 4.0 (2009/01/31) Phillip Lougher

Registering mini_fo version $Id$

JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006                                                                                 Red Hat, Inc.

msgmni has been set to 57

io scheduler noop registered

io scheduler deadline registered (default)

Serial: 8250/16550 driver, 2 ports, IRQ sharing enabled

ăerial8250: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A

serial8250: ttyS1 at MMIO 0xb8000400 (irq = 3) is a 16550A

serial8250.0: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A

serial8250.0: ttyS1 at MMIO 0xb8000400 (irq = 3) is a 16550A

flash init: 0x1c000000 0x02000000

Physically mapped flash: Found 1 x16 devices at 0x0 in 8-bit bank

 CFI mfr 0x00000001

 CFI id  0x000000f6

 Amd/Fujitsu Extended Query Table at 0x0040

  Amd/Fujitsu Extended Query version 1.1.

Physically mapped flash: Swapping erase regions for broken CFI table.

number of CFI chips: 1

Flash device: 0x400000 at 0x1fc00000

bootloader size: 262144

Looking for dual image

Creating 4 MTD partitions on "Physically mapped flash":

0x000000000000-0x000000040000 : "cfe"

0x000000040000-0x0000003f0000 : "linux"

0x000000110000-0x0000003f0000 : "rootfs"

mtd: partition "rootfs" set to be root filesystem

mtd: partition "rootfs_data" created automatically, ofs=2C0000, len=130000

0x0000002c0000-0x0000003f0000 : "rootfs_data"

0x0000003f0000-0x000000400000 : "nvram"

b44: b44.c:v2.0

b44 ssb0:0: eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:90:4c:c0:00:01

BCM47xx Watchdog Timer enabled (30 seconds, nowayout)

TCP westwood registered

NET: Registered protocol family 17

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly on device 31:2.

Freeing unused kernel memory: 148k freed

diag: Detected 'D-Link DIR-320'

b44 ssb0:0: eth0: Link is up at 100 Mbps, full duplex

b44 ssb0:0: eth0: Flow control is off for TX and off for RX

roboswitch: Probing device eth0: found a 5325! It's a 5350.

- preinit -

Press the [f] key and hit [enter] to enter failsafe mode

- regular preinit -

SCSI subsystem initialized

usbcore: registered new interface driver usbfs

usbcore: registered new interface driver hub

usbcore: registered new device driver usb

ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver

ehci_hcd ssb0:1: SSB EHCI Controller

ehci_hcd ssb0:1: new USB bus registered, assigned bus number 1

ehci_hcd ssb0:1: irq 6, io mem 0x18003800

ehci_hcd ssb0:1: USB 0.0 started, EHCI 1.00

hub 1-0:1.0: USB hub found

hub 1-0:1.0: 2 ports detected

ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver

Initializing USB Mass Storage driver...

usbcore: registered new interface driver usb-storage

USB Mass Storage support registered.

usb 1-1: new high speed USB device using ehci_hcd and address 2

scsi0 : usb-storage 1-1:1.0

scsi 0:0:0:0: Direct-Access     Generic  USB Disk         9.02 PQ: 0 ANSI: 2

sd 0:0:0:0: [sda] 234441648 512-byte logical blocks: (120 GB/111 GiB)

sd 0:0:0:0: [sda] Write Protect is off

sd 0:0:0:0: [sda] Assuming drive cache: write through

sd 0:0:0:0: [sda] Assuming drive cache: write through

 sda: sda1 sda2 sda3

sd 0:0:0:0: [sda] Assuming drive cache: write through

sd 0:0:0:0: [sda] Attached SCSI disk

mount: mounting /dev/sda2 on /overlay failed: No such device

switching to jffs2

mini_fo: using base directory: /

mini_fo: using storage directory: /overlay

- init -

b44 ssb0:0: eth0: powering down PHY



Please press Enter to activate this console. b44 ssb0:0: eth0: Link is up at 100 Mbps, full duplex

b44 ssb0:0: eth0: Flow control is off for TX and off for RX

device eth0.0 entered promiscuous mode

device eth0 entered promiscuous mode

br-lan: port 1(eth0.0) entering forwarding state

Compat-wireless backport release: compat-wireless-2010-07-13-3-g1a05138

Backport based on wireless-2.6.git v2.6.35-rc5-47599-ge69e378

cfg80211: Calling CRDA to update world regulatory domain

b43-phy0: Broadcom 5354 WLAN found (core revision 13)

Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ]

cfg80211: World regulatory domain updated:

    (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)

    (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)

    (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)

    (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

    (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)

PPP generic driver version 2.4.2

ip_tables: (C) 2000-2006 Netfilter Core Team

NET: Registered protocol family 24

nf_conntrack version 0.5.0 (465 buckets, 1860 max)

Adding 64224k swap on /dev/sda1.  Priority:-1 extents:1 across:64224k







BusyBox v1.16.2 (2010-07-27 15:28:12 CEST) built-in shell (ash)

Enter 'help' for a list of built-in commands.



  _______                     ________        __

 |       |.-----.-----.-----.|  |  |  |.----.|  |_

 |   -   ||  _  |  -__|     ||  |  |  ||   _||   _|

 |_______||   __|_____|__|__||________||__|  |____|

          |__| W I R E L E S S   F R E E D O M

 KAMIKAZE (bleeding edge, r22394) ------------------

  * 10 oz Vodka       Shake well with ice and strain

  * 10 oz Triple sec  mixture into 10 shot glasses.

  * 10 oz lime juice  Salute!

 ---------------------------------------------------

root@OpenWrt:/#