Forum: [MOD] Tomato by shibby

Kod Pobierz kod źródłowy

Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #7 Sat Oct 20 14:19:48 CEST 2012

CPU revision is: 00019749

Determined physical RAM map:

 memory: 07fff000 @ 00000000 (usable)

Entering add_active_range(0, 0, 32767) 0 entries of 256 used

Zone PFN ranges:

  Normal          0 ->    32767

  HighMem     32767 ->    32767

early_node_map[1] active PFN ranges

    0:        0 ->    32767

On node 0 totalpages: 32767

  Normal zone: 0 pages used for memmap

  Normal zone: 0 pages reserved

  Normal zone: 32767 pages, LIFO batch:7

  HighMem zone: 0 pages used for memmap

Built 1 zonelists.  Total pages: 32767

Kernel command line: root=/dev/mtdblock15 console=ttyS0,115200

Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.

Primary data cache 32kB, 4-way, linesize 32 bytes.

Synthesized TLB refill handler (20 instructions).

Synthesized TLB load handler fastpath (32 instructions).

Synthesized TLB store handler fastpath (32 instructions).

Synthesized TLB modify handler fastpath (31 instructions).

PID hash table entries: 512 (order: 9, 2048 bytes)

CPU: BCM5357 rev 2 pkg 10 at 480 MHz

Using 240.000 MHz high precision timer.

console [ttyS0] enabled

Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)

Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)

Memory: 126464k/131068k available (33k kernel code, 4452k reserved, 2957k data, 128k init, 0k highmem)

Calibrating delay loop... 239.20 BogoMIPS (lpj=1196032)

Mount-cache hash table entries: 512

NET: Registered protocol family 16

usbcore: registered new interface driver usbfs

usbcore: registered new interface driver hub

usbcore: registered new device driver usb

PCI: no core

PCI: no core

PCI: Fixing up bus 0

NET: Registered protocol family 2

Time: MIPS clocksource has been installed.

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 4096 (order: 3, 32768 bytes)

TCP bind hash table entries: 4096 (order: 2, 16384 bytes)

TCP: Hash tables configured (established 4096 bind 4096)

TCP reno registered

squashfs: version 3.0 (2006/03/15) Phillip Lougher

io scheduler noop registered (default)

HDLC line discipline: version $Revision: 4.8 $, maxframe=4096

N_HDLC line discipline registered.

Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled

serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A

PPP generic driver version 2.4.2

MPPE/MPPC encryption/compression module registered

NET: Registered protocol family 24

PPPoL2TP kernel driver, V0.18.3

PPTP driver version 0.8.5

pflash: found no supported devices

Found an ST compatible serial flash with 0 64KB blocks; total size 0MB

sflash: found no supported devices

Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB

nflash: squash filesystem with lzma found at block 6303

Boot partition size = 524288(0x80000)

Creating 16 MTD partitions on "nflash":

0x00000000-0x00080000 : "boot"

0x00080000-0x00200000 : "nvram"

0x00200000-0x00240000 : "board_data"

0x00240000-0x00280000 : "POT1"

0x00280000-0x002c0000 : "POT2"

0x002c0000-0x00300000 : "T_Meter1"

0x00300000-0x00340000 : "T_Meter2"

0x00340000-0x00380000 : "ML1"

0x00380000-0x003c0000 : "ML2"

0x003c0000-0x00400000 : "ML3"

0x00400000-0x00440000 : "ML4"

0x00440000-0x00480000 : "ML5"

0x00480000-0x004c0000 : "ML6"

0x004c0000-0x00500000 : "ML7"

0x00500000-0x02000000 : "linux"

0x00627e88-0x02000000 : "rootfs"

_nvram_init: allocat header: 2280849408, size= 32768

usbcore: registered new interface driver hiddev

usbcore: registered new interface driver usbhid

drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver

u32 classifier

    OLD policer on 

Netfilter messages via NETLINK v0.30.

nf_conntrack version 0.5.0 (1024 buckets, 8192 max)

ip_tables: (C) 2000-2006 Netfilter Core Team

ipt_account 0.1.21 : Piotr Gasidlo , http://www.barbara.eu.org/~quaker/ipt_account/

net/ipv4/netfilter/tomato_ct.c [Oct 20 2012 10:16:49]

NET: Registered protocol family 1

NET: Registered protocol family 10

ip6_tables: (C) 2000-2006 Netfilter Core Team

NET: Registered protocol family 17

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly.

Freeing unused kernel memory: 128k freed

Warning: unable to open an initial console.

emf: module license 'Proprietary' taints kernel.

PCI: Setting latency timer of device 0000:00:02.0 to 64

eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.100.138.20

PCI: Setting latency timer of device 0000:00:01.0 to 64

eth1: Broadcom BCM4329 802.11 Wireless Controller 5.100.138.20

Algorithmics/MIPS FPU Emulator v1.5

SCSI subsystem initialized

Initializing USB Mass Storage driver...

usbcore: registered new interface driver usb-storage

USB Mass Storage support registered.

ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver

PCI: Setting latency timer of device 0000:00:04.1 to 64

ehci_hcd 0000:00:04.1: EHCI Host Controller

ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1

ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000

ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00

usb usb1: configuration #1 chosen from 1 choice

hub 1-0:1.0: USB hub found

hub 1-0:1.0: 2 ports detected

usb 1-1: new high speed USB device using ehci_hcd and address 2

usb 1-1: configuration #1 chosen from 1 choice

scsi0 : SCSI emulation for USB Mass Storage devices

vlan1: add 33:33:00:00:00:01 mcast address to master interface

vlan1: add 01:00:5e:00:00:01 mcast address to master interface

vlan1: dev_set_allmulti(master, 1)

vlan1: dev_set_promiscuity(master, 1)

device eth0 entered promiscuous mode

device vlan1 entered promiscuous mode

scsi 0:0:0:0: Direct-Access     TOSHIBA  MK6459GSX        GK00 PQ: 0 ANSI: 0

sd 0:0:0:0: [sda] 1250263728 512-byte hardware sectors (640135 MB)

sd 0:0:0:0: [sda] Write Protect is off

sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00

sd 0:0:0:0: [sda] Assuming drive cache: write through

sd 0:0:0:0: [sda] Assuming drive cache: write through

 sda:<6>device eth1 entered promiscuous mode

br0: port 2(eth1) entering forwarding state

br0: port 1(vlan1) entering forwarding state

vlan2: Setting MAC address to  84 1b 5e da 6d 05.

vlan2: add 33:33:00:00:00:01 mcast address to master interface

vlan2: add 01:00:5e:00:00:01 mcast address to master interface

 sda1 sda2 sda3

sd 0:0:0:0: [sda] Attached SCSI disk

EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended

kjournald starting.  Commit interval 5 seconds

EXT3 FS on sda2, internal journal

EXT3-fs: mounted filesystem with ordered data mode.

vlan2: del 01:00:5e:00:00:01 mcast address from vlan interface

vlan2: del 01:00:5e:00:00:01 mcast address from master interface

vlan2: del 33:33:00:00:00:01 mcast address from vlan interface

vlan2: del 33:33:00:00:00:01 mcast address from master interface

vlan2: Setting MAC address to  84 1b 5e da 6d 05.

vlan2: add 01:00:5e:00:00:01 mcast address to master interface

vlan2: add 33:33:00:00:00:01 mcast address to master interface

root@Netgear:/tmp/home/root# [b]e2fsck -c dev/sda[/b]
e2fsck 1.38 (30-Jun-2005)
e2fsck: while trying to open dev/sda

The superblock could not be read or does not describe a correct ext2
filesystem. If the device is valid and it really contains an ext2
filesystem (and not swap or ufs or something else), then the superblock
is corrupt, and you might try running e2fsck with an alternate superblock:
e2fsck -b 8193

e2fsck:
root@Netgear:/tmp/home/root# [b]e2fsck -b 8193 dev/sda[/b]
e2fsck 1.38 (30-Jun-2005)
e2fsck: while trying to open dev/sda

The superblock could not be read or does not describe a correct ext2
filesystem. If the device is valid and it really contains an ext2
filesystem (and not swap or ufs or something else), then the superblock
is corrupt, and you might try running e2fsck with an alternate superblock:
e2fsck -b 8193