Forum: [MOD] Tomato by shibby

Cytat

Podłączenie:

Jan 1 01:01:37 unknown user.info kernel: usb 1-2: new high speed USB device using ehci_hcd and address 2
Jan 1 01:01:37 unknown user.debug hotplug[635]: Attached USB device 1-2:1.0 [INTERFACE=8/6/80 PRODUCT=12d1/1f01/102]
Jan 1 01:01:37 unknown user.info kernel: usb 1-2: configuration #1 chosen from 1 choice
Jan 1 01:01:37 unknown user.info kernel: scsi0 : SCSI emulation for USB Mass Storage devices
Jan 1 01:01:37 unknown user.info kernel: usb 1-2: USB disconnect, address 2
Jan 1 01:01:38 unknown user.info kernel: usb 1-2: new high speed USB device using ehci_hcd and address 3
Jan 1 01:01:38 unknown user.info kernel: usb 1-2: configuration #1 chosen from 1 choice
Jan 1 01:01:38 unknown user.debug hotplug[648]: Attached USB device 1-2:1.0 [INTERFACE=2/6/0 PRODUCT=12d1/14db/102]
Jan 1 01:01:38 unknown user.debug hotplug[651]: Attached USB device 1-2:1.1 [INTERFACE=10/6/0 PRODUCT=12d1/14db/102]

lsusb:

Bus 001 Device 003: ID 12d1:14db
Bus 001 Device 001: ID 1d6b:0002

switch3g:

ls: /etc/usb_modeswitch.d/12d1:14db: No such file or directory
ls: /etc/usb_modeswitch.d/1d6b:0002: No such file or directory
rmmod: can't unload 'usbserial': unknown symbol in module, or unknown parameter
rm: can't remove '/tmp/switch3g.lock': No such file or directory
rm: can't remove '/tmp/switch3g.lock': No such file or directory

dmesg po modprobe cdc_ncm:

Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #9 Mon May 19 01:37:04 CEST 2014
CPU revision is: 00019740
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Entering add_active_range(0, 0, 32767) 0 entries of 256 used
Zone PFN ranges:
Normal 0 -> 32767
HighMem 32767 -> 32767
early_node_map[1] active PFN ranges
0: 0 -> 32767
On node 0 totalpages: 32767
Normal zone: 0 pages used for memmap
Normal zone: 0 pages reserved
Normal zone: 32767 pages, LIFO batch:7
HighMem zone: 0 pages used for memmap
Built 1 zonelists. Total pages: 32767
Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM4716 rev 1 pkg 10 at 480 MHz
Using 240.000 MHz high precision timer.
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 126464k/131068k available (33k kernel code, 4444k reserved, 2949k data, 128k init, 0k highmem)
Calibrating delay loop... 239.20 BogoMIPS (lpj=1196032)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Using membase 8000000
PCI: Initializing host
PCI: Reset RC
PCI: no core
PCI: Fixing up bus 0
PCI/PCIe coreunit 0 is set to bus 1.
PCI: Fixing up bridge
PCI: Setting latency timer of device 0000:01:00.0 to 64
PCI: Fixing up bridge
PCI: Setting latency timer of device 0000:01:00.1 to 64
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.18.3
PPTP driver version 0.8.5
Physically mapped flash: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
Physically mapped flash: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Flash device: 0x2000000 at 0x1c000000
Creating 5 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "pmon"
0x00040000-0x01fe0000 : "linux"
0x0013a000-0x00c00000 : "rootfs"
0x00c00000-0x01fe0000 : "jffs2"
0x01fe0000-0x02000000 : "nvram"
Found an serial flash with 0 0KB blocks; total size 0MB
sflash: found no supported devices
_nvram_init: allocat header: 2165768192, size= 32768
usbcore: registered new interface driver hiddev
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
u32 classifier
OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (1024 buckets, 8192 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
ipt_account 0.1.21 : Piotr Gasidlo , http://www.barbara.eu.org/~quaker/ipt_account/
net/ipv4/netfilter/tomato_ct.c [May 19 2014 00:39:40]
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear
All bugs added by David S. Miller
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 128k freed
Warning: unable to open an initial console.
emf: module license 'Proprietary' taints kernel.
PCI: Setting latency timer of device 0000:00:02.0 to 64
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.110.27.20012
wl_module_init: passivemode set to 0x0
PCI: Setting latency timer of device 0000:00:01.0 to 64
eth1: Broadcom BCM4329 802.11 Wireless Controller 5.110.27.20012
Algorithmics/MIPS FPU Emulator v1.5
SCSI subsystem initialized
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
PCI: Setting latency timer of device 0000:00:04.1 to 64
ehci_hcd 0000:00:04.1: EHCI Host Controller
ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:04.1: EHCI Fastpath: New EHCI driver starting
ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000
ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
vlan1: add 33:33:00:00:00:01 mcast address to master interface
vlan1: add 01:00:5e:00:00:01 mcast address to master interface
vlan1: dev_set_allmulti(master, 1)
vlan1: dev_set_promiscuity(master, 1)
device eth0 entered promiscuous mode
device vlan1 entered promiscuous mode
device eth1 entered promiscuous mode
br0: port 2(eth1) entering forwarding state
br0: port 1(vlan1) entering forwarding state
vlan2: Setting MAC address to bc ae c5 c3 cf 1e.
vlan2: add 33:33:00:00:00:01 mcast address to master interface
vlan2: add 01:00:5e:00:00:01 mcast address to master interface
IMQ starting with 2 devices...
IMQ driver loaded successfully.
Hooking IMQ after NAT on PREROUTING.
Hooking IMQ before NAT on POSTROUTING.
usb 1-2: new high speed USB device using ehci_hcd and address 2
usb 1-2: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb 1-2: USB disconnect, address 2
usb 1-2: new high speed USB device using ehci_hcd and address 3
usb 1-2: configuration #1 chosen from 1 choice
usbcore: registered new interface driver cdc_acm
drivers/usb/class/cdc-acm.c: v0.26:USB Abstract Control Model driver for USB modems and ISDN adapters
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
drivers/usb/serial/usb-serial.c: USB Serial support registered for GSM modem (1-port)
usbcore: registered new interface driver option
drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.2
drivers/usb/serial/usb-serial.c: USB Serial support registered for Sierra USB modem
usbcore: registered new interface driver sierra
drivers/usb/serial/sierra.c: USB Driver for Sierra Wireless USB modems: v.1.7.0
usbcore: deregistering interface driver sierra
drivers/usb/serial/usb-serial.c: USB Serial deregistering driver Sierra USB modem
usbcore: deregistering interface driver option
drivers/usb/serial/usb-serial.c: USB Serial deregistering driver GSM modem (1-port)
usbcore: deregistering interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial deregistering driver generic
usbcore: deregistering interface driver usbserial
usbcore: deregistering interface driver cdc_acm
usbcore: registered new interface driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial support registered for generic
usbserial_generic 1-2:1.0: Generic device with no bulk out, not allowed.
usbserial_generic: probe of 1-2:1.0 failed with error -5
usbserial_generic 1-2:1.1: generic converter detected
usb 1-2: generic converter now attached to ttyUSB0
usbcore: registered new interface driver usbserial_generic
drivers/usb/serial/usb-serial.c: USB Serial Driver core
cdc_ncm: 14-Mar-2012
usbcore: registered new interface driver cdc_ncm

próba zmiany WAN na usb:

root@unknown:/tmp/home/root# nvram get wan_ifname
vlan2
root@unknown:/tmp/home/root# nvram set wan_iface=usb0
root@unknown:/tmp/home/root# nvram set wan_ifname=usb0
root@unknown:/tmp/home/root# nvram set wan_ifnames=usb0
root@unknown:/tmp/home/root# nvram set wan_ifnameX=usb0
root@unknown:/tmp/home/root# nvram commit
Commit... done.
root@unknown:/tmp/home/root# MODE="AT^NDISDUP=1,1,\"internet\"" gcom -d /dev/tty
USB0 -s /etc/gcom/setmode.gcom
Trying to set mode
Timeout setting WWAN mode!