Forum: [MOD] Tomato by shibby

Własnie ubiłem Linksys E1000 v2 podczas wgrywania tomato-K26-1.28.RT-MIPSR2-117-Mini

Router zachowuje się dość dziwnie, uruchamiam go, świeci power i zaświeca się jeden z lanów do którego jestem podpięty. Lan ten przez chwile miga, następnie oświeca się na stałe i nawet po wypięciu kabla nadal świeci. Dzieje się tak na wszystkich portach.
Otwarłem router wlutowałem goldpiny i podpiąłem się konsolą. I o dziwo cały proces startu jest wykonywany, router ciągle działa, bo mimo zwieszenia się diody LAN, komunikacja w konsoli po RS232 działa.
Ktoś spotkał się z taką sytuacją?

Kod Pobierz kod źródłowy



Decompressing............done

Start to blink diag led ...





CFE version 5.60.101  based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)

Build Date: 08/04/10 11:22:34 CST (wzh@cybertan)

Copyright (C) 2000-2008 Broadcom Corporation.



Initializing Arena

Initializing Devices.



No DPN

This is a Serial Flash

Boot partition size = 262144(0x40000)

Found a 4MB ST compatible serial flash

Partition information:

boot    #00   00000000 -> 0003FFFF  (262144)

trx     #01   00040000 -> 0004001B  (28)

os      #02   0004001C -> 003F7FFF  (3899364)

nvram   #03   003F8000 -> 003FFFFF  (32768)

Partition information:

boot    #00   00000000 -> 0003FFFF  (262144)

trx     #01   00040000 -> 003F7FFF  (3899392)

nvram   #02   003F8000 -> 003FFFFF  (32768)

BCM47XX_GMAC_ID

et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.60.101

CPU type 0x19749: 300MHz

Total memory: 32768 KBytes



CFE mem:    0x80700000 - 0x807A7B00 (686848)

Data:       0x8073DC00 - 0x80740E40 (12864)

BSS:        0x80740E40 - 0x80741B00 (3264)

Heap:       0x80741B00 - 0x807A5B00 (409600)

Stack:      0x807A5B00 - 0x807A7B00 (8192)

Text:       0x80700000 - 0x8073DBFC (252924)



Boot version: v5.1.6

The boot is CFE

mac_init(): Find mac [98:fc:11:78:e2:8a] in location 0

Nothing...

CMD: [ifconfig eth0 -addr=192.168.1.1 -mask=255.255.255.0]

Device eth0:  hwaddr 98-FC-11-78-E2-8A, ipaddr 192.168.1.1, mask 255.255.255.0

        gateway not set, nameserver not set

CMD: [go;]

Check CRC of image1

  Len:     0x37A000     (3645440)       (0xBC040000)

  Offset0: 0x1C         (28)            (0xBC04001C)

  Offset1: 0xAD8        (2776)  (0xBC040AD8)

  Offset2: 0xD4000      (868352)        (0xBC114000)

  Header CRC:    0xB2828294

  Calculate CRC: 0xB2828294

Image 1 is OK

Try to load image 1.

Waiting for 5 seconds to upgrade ...

CMD: [load -raw -addr=0x807a7b00 -max=0x1858500 :]

Loader:raw Filesys:tftp Dev:eth0 File:: Options:(null)

Loading: _tftpd_open(): retries=0/5

_tftpd_open(): retries=1/5

_tftpd_open(): retries=2/5

_tftpd_open(): retries=3/5

_tftpd_open(): retries=4/5



### Start=619415120 E=1585004468 Delta=965589348 ###

Failed.

Could not load :: Timeout occured

CMD: [boot -raw -z -addr=0x80001000 -max=0x6ff000 flash0.os:]

Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)

Loading: .. 5192 bytes read



### Start=1589326080 E=1591435720 Delta=2109640 ###

Entry at 0x80001000

Closing network.

Starting program at 0x80001000

Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #22 Mon Apr 14 14:07:33 CEST 2014

CPU revision is: 00019749

Found a 4MB ST compatible serial flash

Determined physical RAM map:

 memory: 02000000 @ 00000000 (usable)

Built 1 zonelists.  Total pages: 8128

Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200

Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.

Primary data cache 32kB, 4-way, linesize 32 bytes.

Synthesized TLB refill handler (20 instructions).

Synthesized TLB load handler fastpath (32 instructions).

Synthesized TLB store handler fastpath (32 instructions).

Synthesized TLB modify handler fastpath (31 instructions).

PID hash table entries: 128 (order: 7, 512 bytes)

CPU: BCM5357 rev 1 pkg 8 at 80 MHz

Using 40.000 MHz high precision timer.

console [ttyS0] enabled

Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)

Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)

Memory: 29712k/32768k available (33k kernel code, 3056k reserved, 2456k data, 112k init, 0k highmem)

Mount-cache hash table entries: 512

NET: Registered protocol family 16

PCI: no core

PCI: Fixing up bus 0

Time: MIPS clocksource has been installed.

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 1024 (order: 1, 8192 bytes)

TCP bind hash table entries: 1024 (order: 0, 4096 bytes)

TCP: Hash tables configured (established 1024 bind 1024)

TCP reno registered

squashfs: version 3.0 (2006/03/15) Phillip Lougher

io scheduler noop registered (default)

HDLC line discipline: version $Revision: 4.8 $, maxframe=4096

N_HDLC line discipline registered.

Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled

çerial8250: ttyS0 at MMIO 0xb8000300 (irq = 8) is a 16550A

PPP generic driver version 2.4.2

MPPE/MPPC encryption/compression module registered

NET: Registered protocol family 24

PPPoL2TP kernel driver, V0.18.3

PPTP driver version 0.8.5

pflash: found no supported devices

Creating 5 MTD partitions on "sflash":

0x00000000-0x00040000 : "pmon"

0x00040000-0x003f0000 : "linux"

0x00114000-0x003c0000 : "rootfs"

0x003c0000-0x003f0000 : "jffs2"

0x003f0000-0x00400000 : "nvram"

u32 classifier

    OLD policer on

Netfilter messages via NETLINK v0.30.

nf_conntrack version 0.5.0 (512 buckets, 4096 max)

ip_tables: (C) 2000-2006 Netfilter Core Team

ipt_account 0.1.21 : Piotr Gasidlo , http://www.barbara.eu.org/~quaker/ipt_account/

net/ipv4/netfilter/tomato_ct.c [Apr 14 2014 14:07:33]

NET: Registered protocol family 1

NET: Registered protocol family 17

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly.

Freeing unused kernel memory: 112k freed

Warning: unable to open an initial console.

emf: module license 'Proprietary' taints kernel.

eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.147.0

eth%d: 5.10.147.0 driver failed with code 12

/ # vlan0: No such device

eth1: No such device

eth2: No such device

eth3: No such device

lo: File exists

tomato-K26-1.28.RT-MIPSR2-117-Mini