Decompressing...done


CFE version 6.30.39.16 (r331229) based on BBP 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Fri Jun 1 10:34:33 CST 2012 (defjovi@F13)
Copyright (C) 2000-2008 Broadcom Corporation.

Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
bcm_robo_enable_switch: EEE is disabled
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.30.39.16 (r331229)
CPU type 0x19749: 600MHz
Tot mem: 131072 KBytes

CFE mem: 0x80700000 - 0x8084E720 (1369888)
Data: 0x807384B0 - 0x8073B750 (12960)
BSS: 0x8073B750 - 0x8074C720 (69584)
Heap: 0x8074C720 - 0x8084C720 (1048576)
Stack: 0x8084C720 - 0x8084E720 (8192)
Text: 0x80700000 - 0x807384A8 (230568)

Device eth0: hwaddr 10-BF-48-D8-A9-18, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
Null Rescue Flag.
boot the image...
go load
Loader:raw Filesys:tftp Dev:eth0 File:: Optionsnull)
Loading: TFTP Server.
Failed.
Could not load :: Timeout occured
Loader:raw Filesys:raw Dev:nflash0.os File: Optionsnull)
Loading: ...... 3322620 bytes read
Entry at 0x80001000
Closing network.
Starting program at 0x80001000
Linux version 2.6.22.19 (root@asus) (gcc version 4.2.4) #1 Thu Sep 6 19:17:17 CST 2012
CPU revision is: 00019749
Found an ST compatible serial flash with 32 64KB blocks; total size 2MB
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
memory: 08000000 @ 87fff000 (usable)
Zone PFN ranges:
Normal 0 -> 131072
HighMem 131072 -> 589823
early_node_map[2] active PFN ranges
0: 0 -> 32767
0: 557055 -> 589823
Built 1 zonelists. Total pages: 65535
Kernel command line: root=/dev/mtdblock3 console=ttyS0,115200 init=/sbin/preinit
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM5300 rev 1 pkg 0 at 600 MHz
Using 300.000 MHz high precision timer.
console [ttyS0] enabled
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 254916k/131068k available (2525k kernel code, 6932k reserved, 515k data, 204k init, 131072k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Initializing host
PCI: Reset RC
PCI: Initializing host
PCI: Reset RC
PCI: Fixing up bus 0
PCI/PCIe coreunit 0 is set to bus 1.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:01:00.1 (0004 -> 0006)
PCI: Fixing up bus 1
PCI/PCIe coreunit 1 is set to bus 2.
PCI: Fixing up bridge
PCI: Fixing up bridge
PCI: Enabling device 0000:02:00.1 (0004 -> 0006)
PCI: Fixing up bus 2
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
highmem bounce pool size: 64 pages
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
serial8250: ttyS1 at MMIO 0x0 (irq = 8) is a 16550A
PPP generic driver version 2.4.2
MPPE/MPPC encryption/compression module registered
NET: Registered protocol family 24
PPPoL2TP kernel driver, V0.18.3
PPTP driver version 0.8.5
pflash: found no supported devices
Boot partition size = 262144(0x40000)
Creating 2 MTD partitions on "sflash":
0x00000000-0x00040000 : "pmon"
0x001f0000-0x00200000 : "nvram"
Found a Samsung NAND flash with 2048B pages or 128KB blocks; total size 128MB
lookup_nflash_rootfs_offset: offset = 0x0
nflash: squash filesystem with lzma found at block 9
Creating 2 MTD partitions on "nflash":
0x00000000-0x02000000 : "linux"
0x001313d8-0x02000000 : "rootfs"
NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bit)
Creating 2 MTD partitions on "brcmnand":
0x00000000-0x02000000 : "trx"
0x02000000-0x07f00000 : "brcmnand"
dev_nvram_init: _nvram_init
_nvram_init: allocat header: 2280980480, size= 65536
sdhci: Secure Digital Host Controller Interface driver
sdhci: Copyright(c) Pierre Ossman
u32 classifier
OLD policer on
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (2048 buckets, 16384 max)
ipt_time loading
ip_tables: (C) 2000-2006 Netfilter Core Team
net/ipv4/netfilter/tomato_ct.c [Sep 6 2012 19:16:41]
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear
All bugs added by David S. Miller
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 204k freed
Warning: unable to open an initial console.
Failed to execute /sbin/preinit. Attempting defaults...
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
hotplug net INTERFACE=lo ACTION=add
block hotplug INTERFACE=(null) ACTION=add USBPORT=(null) HOST=(null) DEVICE=(null)
hotplug net INTERFACE=lo ACTION=add
set_action 0
[1:init_nvram +5] init_nvram for 10
ctf: module license 'Proprietary' taints kernel.
et_module_init: passivemode set to 0x0
et_module_init: et_txq_thresh set to 0x400
bcm_robo_enable_switch: EEE is disabled
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.30.39.31 (r341183)
hotplug net INTERFACE=eth0 ACTION=add
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
eth1: Broadcom BCM4331 802.11 Wireless Controller 6.30.39.31 (r341183)
PCI: Enabling device 0000:02:01.0 (0000 -> 0002)
eth2: Broadcom BCM4360 802.11 Wireless Controller 6.30.39.31 (r341183)
hotplug net INTERFACE=eth1 ACTION=add
hotplug net INTERFACE=eth2 ACTION=add
[1:init_main +7] main loop signal/state=17