Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #2 Sun Jul 25 09:59:08                                                                                                                                                              EDT 2010

CPU revision is: 00019749

Found a 4MB ST compatible serial flash

Determined physical RAM map:

 memory: 01000000 @ 00000000 (usable)

On node 0 totalpages: 4096

  Normal zone: 32 pages used for memmap

  Normal zone: 0 pages reserved

  Normal zone: 4064 pages, LIFO batch:0

Built 1 zonelists.  Total pages: 4064

Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200

Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.

Primary data cache 32kB, 4-way, linesize 32 bytes.

Synthesized TLB refill handler (20 instructions).

Synthesized TLB load handler fastpath (32 instructions).

Synthesized TLB store handler fastpath (32 instructions).

Synthesized TLB modify handler fastpath (31 instructions).

PID hash table entries: 64 (order: 6, 256 bytes)

CPU: BCM5356 rev 1 pkg 4 at 300 MHz

Using 150.000 MHz high precision timer.

Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)

Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)

Memory: 13464k/16384k available (2060k kernel code, 2920k reserved, 437k data, 1                                                                                                                                                             08k init, 0k highmem)

SLUB: Genslabs=6, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1

Calibrating delay loop... 148.99 BogoMIPS (lpj=74496)

Mount-cache hash table entries: 512

NET: Registered protocol family 16

PCI: no core

PCI: Fixing up bus 0

Time: MIPS clocksource has been installed.

NET: Registered protocol family 2

IP route cache hash table entries: 1024 (order: 0, 4096 bytes)

TCP established hash table entries: 512 (order: 0, 4096 bytes)

TCP bind hash table entries: 512 (order: -1, 2048 bytes)

TCP: Hash tables configured (established 512 bind 512)

TCP reno registered

squashfs: version 3.0 (2006/03/15) Phillip Lougher

io scheduler noop registered (default)

HDLC line discipline: version $Revision: 4.8 $, maxframe=4096

N_HDLC line discipline registered.

Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled

serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A

PPP generic driver version 2.4.2

NET: Registered protocol family 24

PPPoL2TP kernel driver, V0.17

PPTP driver version 0.8.4

pflash: found no supported devices

Creating 5 MTD partitions on "sflash":

0x00000000-0x00020000 : "pmon"

0x00020000-0x003f0000 : "linux"

0x000f8400-0x003a0000 : "rootfs"

0x003a0000-0x003f0000 : "jffs2"

0x003f0000-0x00400000 : "nvram"

u32 classifier

    OLD policer on

Netfilter messages via NETLINK v0.30.

nf_conntrack version 0.5.0 (512 buckets, 4096 max)

ip_tables: (C) 2000-2006 Netfilter Core Team

NET: Registered protocol family 1

NET: Registered protocol family 17

802.1Q VLAN Support v1.8 Ben Greear 

All bugs added by David S. Miller 

VFS: Mounted root (squashfs filesystem) readonly.

Freeing unused kernel memory: 108k freed

Warning: unable to open an initial console.

et: module license 'unspecified' taints kernel.

PCI: Setting latency timer of device 0000:00:02.0 to 64

eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.46

PCI: Setting latency timer of device 0000:00:01.0 to 64

eth1: Broadcom BCM4338 802.11 Wireless Controller 5.10.56.46

net/ipv4/netfilter/tomato_ct.c [Jul 25 2010 09:51:01]

Algorithmics/MIPS FPU Emulator v1.5

vlan0: add 01:00:5e:00:00:01 mcast address to master interface

vlan0: dev_set_promiscuity(master, 1)

device eth0 entered promiscuous mode

device vlan0 entered promiscuous mode

device eth1 entered promiscuous mode

br0: port 2(eth1) entering learning state

br0: port 1(vlan0) entering learning state

br0: topology change detected, propagating

br0: port 2(eth1) entering forwarding state

br0: topology change detected, propagating

br0: port 1(vlan0) entering forwarding state

vlan1: Setting MAC address to  48 5b 39 c8 d3 4f.

vlan1: add 01:00:5e:00:00:01 mcast address to master interface

vlan1: del 01:00:5e:00:00:01 mcast address from vlan interface

vlan1: del 01:00:5e:00:00:01 mcast address from master interface

br0: port 2(eth1) entering disabled state

br0: port 1(vlan0) entering disabled state

vlan0: del 01:00:5e:00:00:01 mcast address from vlan interface

vlan0: del 01:00:5e:00:00:01 mcast address from master interface

device vlan0 left promiscuous mode

br0: port 1(vlan0) entering disabled state

device eth1 left promiscuous mode

br0: port 2(eth1) entering disabled state

vlan0: add 01:00:5e:00:00:01 mcast address to master interface

device eth1 entered promiscuous mode

br0: port 2(eth1) entering learning state

br0: port 1(vlan0) entering learning state

br0: topology change detected, propagating

br0: port 2(eth1) entering forwarding state

br0: topology change detected, propagating

br0: port 1(vlan0) entering forwarding state

vlan1: Setting MAC address to  48 5b 39 c8 d3 4f.

vlan1: add 01:00:5e:00:00:01 mcast address to master interface

CPU: BCM5356 rev 1 pkg 4 at 300 MHz

Using 150.000 MHz high precision timer.

........

Calibrating delay loop... 148.99 BogoMIPS (lpj=74496)